ZVS High-frequency Induction Low Power Heating Tesla Generator 120W60w5-12V Mini Module
Store Name: GoodVendor Store
Rating: 5.0 / 5.0
Spesification
Description
type1:Spare parts are not welded with heating coil, high pressure package.
type2:Heating coil for spare parts without welding band
type3:PCB circuit board, without parts.
Heating iron bar below 3mm diameter;
This is a mini ZVS suite, compact package, can not use ordinary battery power supply, it is recommended to use high-power switching power supply, 5 to 12 V power supply current should not be less than 5A!!! Attention should be paid to the use of high-power power supply, sufficient power, working voltage less than 5V does not work, current less than 5A does not work.
The working voltage should not exceed 12V or less than 5V. It only refers to the working voltage of the circuit, not the no-load output voltage of the power supply. More than 12V or less than 5V power supply, circuit is easy to problem, the seller is not responsible!
The 12V power supply pushes the high pressure package, the power is about 60W, the MOS tube does not generate heat, and there is no need for auxiliary heat dissipation. If used as induction heating, please do not work for long, after all, the power is limited, induction heating primary coil heating is relatively large, pay attention to heat dissipation.
Make sure that all components are welded correctly, and the positive and negative poles of the power cord are not connected to each other. After the load is connected (heating coil, high-voltage package), the power is re-energized. No load, no electricity! No-load power is easily damaged.No load power on 2 MOS tubes are easy to connect at the same time, and then burn out!
Maximum power 120W (12V induction heating)
The use of battery and battery power supply must ensure that the working voltage is above 4.5V.Do not ensure that the voltage at work is always above 4.5V, do not use battery and battery power supply!Do not use dry battery power!
Heating coilThe width of the heated object is as high as 1/3~1/2 of the inner diameter of the heating coil, and the maximum should not exceed 2/3.
The diameter of the heated object should be controlled within 8 mm as far as possible. It will be difficult to heat to bright red if heated too much. After all, the power is limited.
Induction heating, general work 5 minutes to cut off the electricity cooling. Because induction heating has larger current and larger coil heating.When heated, part of the heat generated by the heated object will be transferred to the heating coil, and the temperature of the heating coil will be very high over a long period of time.. If the heating coil is connected to the connection terminal, it will melt the plastic part of the terminal.
Buyers praise
Kit parts, with heating coil, need to coil around.
Welding finished product effect diagram
Induction heating, equipped with a simple heating coil, coil for a section of copper wire needs to be wound by itself, when heating, please pay attention to heat dissipation, the heating coil made of hollow copper tube with water is better for heat dissipation.
Test results:Because it is a mini type with limited power, it can simply heat small objects and not melt metals.
Refer to professional handheld high-frequency induction heater.
Induction heating can also be applied to metal smelting.
\'
Package Detail
- Unit Type:piece
- Package Weight:0.5kg (1.10lb.)
- Package Size:10cm x 10cm x 10cm (3.94in x 3.94in x 3.94in)
0 comments:
Post a Comment