Mini ZVS Induction Heating Tapped High Frequency Heater Jacob Ladder Drive
Store Name: GoodVendor Store
Rating: / 5.0
Spesification
Description
1. This tap free mini board ZVSFinished plateWithout heating coil, high pressure bag, cooling fan, etc.
\\
\\
2. This suiteRequires a certain degree of hands-on ability and related knowledge.. If the iron is not used and the power supply will not be divided, it is recommended not to shoot. The seller has no responsibility for the problem.
\\
\\
3.Maximum power 120W (12V induction heating).Push high pressure bag 12V, primary 5+5 turn around, 30W or so.
\\
\\
4, input voltage DC 5V~12V, this voltage range is working voltage, not the power supply voltage when no load.
\\
\\
(Sellers with voltages above 12V or below 5V are not guaranteed to work properly, input voltages are not within this range, and sellers are not liable for problems!)
\\
\\
The use of battery and battery power supply must ensure that the working voltage is above 4.5V.Do not ensure that the voltage at work is always above 4.5V, do not use battery and battery power supply!Do not use dry battery power!
\\
\\
5. Make sure all the components are welded correctly, and the positive and negative poles of the power line are not connected to each other. After the load is connected (heating coil, high-voltage package), power on again! No load, no electricity! No-load power is easily damaged.
\\
\\
\\
\\
6, PCB board size: long * width * thickness 55mm*37mm*1.6mm
\\
\\
Heating coil
\\
The width of the heated object is as high as 1/3~1/2 of the inner diameter of the heating coil, and the maximum should not exceed 2/3.
\\
\\
The diameter of the heated object should be controlled within 20 mm as far as possible. It is difficult to heat the object to red when heated too much. After all, the power is limited.
\\
\\
Induction heating, general work 5 minutes to cut off the electricity cooling. Because induction heating has larger current and larger coil heating.When heated, part of the heat generated by the object being heated is transferred to the heating coil, and over time, the temperature of the heating coil is very high.. If the heating coil is connected to the connection terminal, it will melt the plastic part of the terminal. Therefore, it is better to directly weld the heating coil to the PCB board when induction heating..Buyers please pay attention to this.
\\
\\
Long time use suggests using copper tubes to make coils and water cooling.
\\
\\
\\
\\
9,Pushing high-pressure package, induction heating current, input voltage, the number of primary turns, heating coil turns, the volume of the object to be heated. Our test is for reference only.
\\
\\
Blue LED power indicator, there is electricity, no lights to see if you know!
\\
\\
The reason for the failure of the indicator is: 1, the line is not connected, and the power is not energized. 2, the boards are damaged by components.
\\
\\
\\
\\
\\
\\
When the indicator light is dim, it should be the power supply is insufficient, and the power supply needs to be replaced.
\\
\\
\\
\\
1
\\
Hot iron block size: long * width * high 30*10*4mm
\\
\\
\'
Package Detail
- Unit Type:lot (2 pieces/lot)
- Package Weight:0.5kg (1.10lb.)
- Package Size:10cm x 10cm x 10cm (3.94in x 3.94in x 3.94in)
0 comments:
Post a Comment